Pinwheel Welcome Wreath
Hello, friends.. Shellye here with you today! After putting away my Spring wreaths this past week, I decided that I was in need of a new Summery wreath for our carport entry. The idea of a pinwheel wreath caught my attention while visiting Pinterest, so I went from there! You can use any type of wreath: straw, stryofoam, grapevine, etc.
I kept this very simple by using sheets from the "Good Day Sunshine" 6X6 Paper Pad. You can also cut your favorite 12X12 sheets to 6X6 size. I've used a total of ten 6X6 sheets for this project.
Using a ruler and pencil, draw a line from one end to the opposite end and then repeat with the other side so that you have an "X" over the paper. Next, I traced a small 1" circle around the center of the "X"...this gave me a guide of how far to cut the lines.
Using scissors or a paper trimmer, cut along each line up to the circle. Next, use a 1/8" hole punch, make a hole at the RIGHT hand corner of each triangular flap. Punch a hole at the center of the "X".
Insert a large brad through each of the flap's holes and then through the center.
I attached my pinwheels to a 14" grapevine wreath. I wrapped a piece of thin gauged wire around (the backside of the pinwheel) the brad's prongs and then gave a good twist. Thread the wire ends through the grapevine and twist together at the back of the wreath.
I also wanted a focal point to the wreath, so I covered a piece of scalloped chipboard and decorated with some pieces from the "Good Day Sunshine" Collection.
Make smaller pinwheels, larger pinwheels or a mix of both! There are so many ideas for making these fun wreaths. And because I work in Labor & Delivery, I also thought this design would be so cute as a "welcome baby" door hanger made with the new "Hello Baby" Collection :)
Thank you for visiting us at Simple Stories!